◇ use cases

Custom-fit miniature cases for every figure you own

MyMiniCase turns the STL of a miniature into a 3D-printable case with a cavity shaped to that figure and a sliding lid. It runs in your browser, the STL never leaves your computer, and the result prints on any FDM or resin printer. The pages below go deeper into specific situations.

By what you need the case for

Start from the problem. Each page explains how the carved cavity and sliding lid handle that job, and what to set before you print.

storageMiniature storage case — dust-free, one figure per slot transportArmy transport case for tournaments and game nights foam replacementA rigid alternative to pluck foam trays

By scale

The cavity follows the STL, so any scale works — but clearance, wall and lid settings change with size.

28 mm28 mm miniature case — heroic-scale skirmish and RPG figures 32 mm32 mm miniature case — modern wargame sculpts 54 mm54 mm miniature case — display and historical figures

By type of piece

charactersCharacter and hero miniature case squadsInfantry squad case — several figures, one carrier large modelsCase for monsters, vehicles and large models

By game

Compatibility pages for the systems our users play most. The case is made from your STL, so it works with any game; these pages cover the base sizes and habits of each.

compatible with Warhammer 40,000Case for Warhammer 40k miniatures — every base size compatible with D&DCase for D&D and tabletop RPG miniatures

Carve a case around your own miniature

Drop the STL into your browser, tune the clearance, and download a case with a sliding lid. Three free cases on an email address — no card.

Start the free trial